Put on the electrodes & connect the cable as shown with the "white" connector on the right and the "Red" connector on the left.

You will hear the message "Hello Jingle"; this means you are connected.

If you did not hear "Hello Jingle", press the button to activate

Wear around on the neck, on the belt or in the pocket.

Remove the lead wires

You will hear the message "Bye Jingle"; this means you are disconnected.

Do not scrub the electrodes. Replace electrodes every 2 days or as required.

Connect the lead wires

You will hear the message "Hello Jingle"; this means you are connected.

You sense symptoms eg chest pain, chest tightness, chest pressure and chest discomfort, shortness of breath. pain, numbness, weakness or coldness in limbs etc 

Press the "RED" button firmly & release

myCam records 40 secs stored & 40 secs more

When finished recording, myCam will beep twice

myCam detects recording trigger

Recording begins automatically

You will hear a long beep sound once recording has been done. myCam stores 2 automatic recordings

Once full, send the recording to clear the memory. myCam records 2 automatic recordings and 2 manual recordings.

Detach the buttons from the electrodes

Place myCam near the mouthpiece with the sound holes beside the phone receiver. Press the red button to begin

Call the phone number

66-(02)-0261692 & listen for instructions

The sound transmission will take up to 4 minutes. Once completed, please listen for further instructions.

After the beep, say your name

Once transmission is confirmed, reconnect lead wires to the electrodes.